Seven criteria for car charging station maintenance

Car charging station maintenance method

Charging must pay attention to the charging time, do not charge once, that will make the capacitance increase, will only make the battery scrap, also do not pull out a while, occasionally can pull out, but more times, will make the battery capacity reduced, so the daytime charging pile can control the time, generally wait for the red light jump green light after the floating charge on the line! Winter float time 4 hours, summer 2 hours float time! First plug the battery in, then plug it in again, and when charging is over, unplug it first, then unplug the battery. Connect the charging post to the battery, then put the remaining socket of the charging post in. As China's electric car charging mode is not uniform, the start is late, are feeling the stones to cross the river, there is no corresponding standard for reference, plus charging piles and cars are new things, in the production and research and development of the basis of everyone has no experience, so the standard design for the charging piles will also have deficiencies and corresponding defects, some charging piles or a car a pile, can only meet a car charging, so it also caused Some charging posts are still designed for one vehicle and can only accommodate one vehicle, thus creating a mixed situation of charging interfaces. When charging an electric car, first of all, the charging socket should correspond to the charging socket, then connect the charging socket to the charging socket in order to observe whether the electric light is charging (generally the red light is on to indicate charging in progress, the green light is on to indicate basic sufficiency, the more discharge, the longer the charging time). The electric vehicle charging pile market is developing rapidly. Due to insufficient investment in the early stage, most of the construction process is abandoned, so it is especially important for the advantages of electric vehicles in the future construction process. Charging piles should be checked before charging whether their equipment is intact, whether the cable is intact, whether it is raining or if there is no canopy in winter do not use the car charging piles outdoors to avoid the danger caused by walking electricity. After the light bulb is lit, go to the host and swipe the card within three minutes, otherwise unplug the charging post and wait for two minutes before plugging it in again. In addition, there are many problems in the actual use of the charging post. When the designers were stacking and constructing the charging post, they found some problems and took corresponding measures to solve them, making its use more safe and reliable, convenient and comfortable.

    An electric vehicle charging station is a public charging device that is installed by the charging station operator or property company in a parking space and used to charge energy vehicles in the area. The number of cycles of battery charging and discharging cycles is certain, generally around 600-800 times. Charging once is equivalent to changing one charging and discharging cycle, and charging the battery frequently means shortening the life of the battery. However, electric vehicles will last a long time after charging, once there is no electricity during the driving process, it will make the driver embarrassed. In order to maintain the charging pile in time charging pile many people are directly thrown into the luggage compartment of the electric car after charging, did you know that? During the driving process of electric cars, vibration occurs due to bumps, which will damage the charging pile in the trunk, and when damaged, it will lead to a slower charging speed and affect the service life of the battery. When the charging post is pulled out, overloaded or filled during tram charging, the current charging charge is automatically settled and the current charging balance is credited to the charging station, which will automatically return to the user's charging card when the user swipes it again. Do not place dangerous items such as flammable, explosive or combustible materials, chemicals or flammable vapours near the vehicle charging station. The balance on the card and the number of the socket to be used will be displayed on the main unit after the card has been swiped. If the balance on the card has been full for 10 hours, it can be recharged and used again.

This aspect creates a problem of mismatch between charging posts and electric vehicles produced by various manufacturers. It acts similarly to a petrol engine and can be fixed to the floor or wall, installed in public buildings or in residential car parks or charging stations, and can charge various models of electric vehicles depending on the voltage level. The socket number shown on the screen and the socket number inserted by the charging post are confirmed correctly before the card is swiped and the socket is ready for power supply. Revenue enquiry: The amount of money spent by the user swiping the card can be counted automatically and the operations manager can check the current revenue situation via the revenue enquiry card. Connect the charging gun head clean and dry, if there is any stain, please wipe it with a clean and dry cloth, it is strictly forbidden to touch the charging gun core by hand when it is charged. It is therefore advisable to place the charging gun in a special cushioning foam compartment. This rechargeable device, with a jack and discharge port, casts one hard charge for 10 minutes, two hard charges for 20 minutes, three hard charges for 30 minutes and four hard charges for 40 minutes. It is understood that a rechargeable car can run for 5-6 kilometres, which is equivalent to being able to run for 15 minutes. Frequent use of electric cars, should choose to charge the battery when the remaining power 20%-30%, so as to avoid both early battery deactivation phenomenon, but also to avoid the battery over-discharge.

In addition the interface protocols between the two charging posts are not compatible at the time of design. Quick use fast charging: each jack is only suitable for charging one electric vehicle, do not connect other loads privately, and do not connect a plug-in board to charge two electric vehicles privately, so as not to burn out the fuse or automatically cut off the power, violators are held responsible. Due to the tight parking space in the city, electric cars take up part of the public parking space and management problems ensue. The input side of the charging pile is directly connected to the AC grid and the output side are equipped with charging plugs for charging electric vehicles. If the time is too short to run 60%-70% of the long mileage in a week, it is recommended to charge once a week. Power failure memory: In case of an unexpected power failure, it can automatically save the current charging time and status information of each circuit. Users pay for the charge through bets,, apps etc. The swipe action should not be too fast, look at what is displayed on the screen and give the device some response time.

After the fast charging starts, please check if your electric vehicle is charging, normally for normal charging, the red light will be on, please turn off the power before charging. There are two main charging methods: regular charging and fast charging. Users can use the special charging pile charging card by swiping it on the man-machine interactive operation interface to realise the corresponding charging methods, charging time, charging data printing and other operations, and the charging pile display can show charging power, charging data, charging time and other data. In order to make the electric car parking spaces work, the operation and management of electric cars also increases the cost. Regular maintenance is carried out on the EV battery and the battery is fixed to the EV to prevent damage from battery vibration during cycling. Once again the call comes in and automatically reverts back to the pre-disconnection period to continue charging. This is done by checking the working status of the charging unit and confirming that the power supply is normal. Private installation is difficult private charging piles will encounter many problems, such as installation site selection, property communication, power submission, construction and installation, etc. Considering safety factors, community property may not cooperate, and if it is installed in old communities, it is likely to face the problem of insufficient capacitance in old communities. If you go out or do not use it for a long time, it is recommended to replenish the electricity once a month and keep the electric car in a cool and dry place.

It is also difficult for pure electric vehicle owners to install charging posts in their parking spaces as well. Charging posts (car charging posts). Car charging piles or charging cables are not allowed to be defective during use. Cracks, wear and tear, broken charging cables, etc. are found and if found, contact the part-time staff in time. The fast pile (bolt) unit has an integrated AC/DC structure. For vehicles with vehicle-mounted charging piles, the rear of the vehicle will be charged. How to achieve the true compatibility of the cell charging pile, the new national standard cell charging pile for the previous cell charging pile model is not uniform, difficult to be compatible with a variety of electric vehicles shortcomings, proposed a new standard to help domestic cell charging pile and electric vehicle enterprises in the process of production and research and development, to strengthen the compatibility with the unified standard, thus improving the adaptability between electric vehicles and cell charging pile. Do not attempt to damage, repair or modify car charging posts, if there is repair or modification, please contact part-time staff, illegal operation may lead to damage, leakage, power failure and other circumstances. No user charges will be lost.

Most of the early construction of community charging piles are centralized station type, far away from the city, without taking into account the actual needs of electric car owners, very inadequate in use and access, such new energy charging infrastructure is the driving force behind the development of the electric car market. Long periods of charging should be properly controlled within 8-10 hours, not more than 8 hours in summer and not more than 10 hours in winter. It is important to clean the dust and objects on the battery box frequently, and pay attention to keep the battery dry and clean to prevent it from discharging automatically. Recharge card balance enquiry: directly swipe the card in the card swipe area, you can inquire the current balance of the user's recharge card, recharge card balance enquiry does not deduct the card. Enables both DC charging and AC charging. Currently scan QR code and start charging, charging pile support, APP, small program and other charging methods. Do not change the car when charging, otherwise it may damage the battery, cast do not cast too much at once, confirm how much charge you have. Repair, refurbishment, please contact part-time staff, illegal operation may lead to damage, leakage, power failure and other environment.

Luoyang Grasen Power Technology Co., Ltd is a professional AC home charger and DC fast charger EV supercharger manufacturer for 11 years in China, the charging connectors can be any two of CCS1/CCS2/CHAdeMO/GBT. Please enter our website for more information: https://www.grasen.com. Please send email to sales@grasen.com for inquiry.